Specializing in lighting for 20 years

Led fluorescent tube installation method instructions

Date:24-07-2017

   Led fluorescent tube as a combination of tube and bracket, commonly known as integrated fluorescent tube, usually divided into led fluorescent tube and T5 integrated led fluorescent tube, T8 integrated led fluorescent tube size is relatively large, light angle is also large, T5 one Led fluorescent tube just the opposite.
   1. Structure: There are two kinds of power, one is single-ended power, plug the plug, power on the light. One is double-ended power. The internal AC lines are parallel and are equipped with connectors for the purpose of being used in series.
The basic accessories are: three-core power plug, fixed bracket metal buckle two, for connecting the lamp connection plug.
   2. How to connect the three wires
  Usually the two lines are the same as the power supply, there is a line is the ground. Rangter marked the yellow line is the ground line. So how to judge the ground line. Ground and the base is connected, if it is aluminum bracket, then the ground will be connected with the aluminum bracket, which can determine which ground is the ground. Therefore, the authentic integration of led lamp shell is aluminum fishes, one is good heat dissipation, the second is good grounding and security. If the double-ended conductive, T5 integrated LED tube can be used in series, including the professional design of the built-in power supply, direct input voltage AC220V ~ 50Hz, direct installation.
   3. Installation Note: The product is installed to cut off the power after the accident, to avoid accidents. Non-professionals do not repair, maintain, disassemble and disassemble the lamp.
   4. The biggest features: including led drive power, no need ballast, power on the light.
   5. How do you install T5 integrated fluorescent tube?
   Install the T5LED integrated bracket, first to determine the location of the LED bracket installation. General house is rectangular, if used to install on the wall, but also pay attention to the balance of the installation of accessories.
   First measure the distance between the two side buckle buckle, and then the hammer has the buckle were set into the wall. Pay attention to keep the buckle horizontal symmetrical T5LED integrated led lamp holder into the accessories buckle
   Hand holding T5LED integrated support of the plastic body, hear the "carbazole" sound, to prove that after the card, the same way to install the other side. Note, do not hand holding the glass directly into the card, so as not to force the point is not correct but damage the LED bracket.
   6. Connect the wire to power
    The T5LED integrated fluorescent tube bracket of the two input lines were connected with the zero power supply, respectively. After receiving the wire, you can try to power, if everything is normal, you're done. Integration is very simple, as long as the connector (manufacturers will be allocated) into the lamp, and then the yellow-green line grounding, the other two can be connected to the line and the zero line.
   7. Note, the use of series, according to led tube power size, such as 18w, generally up to 20 lamp.http://www.new-lights.com/